From p.j.coleman-smith@dl.ac.uk Mon May 12 11:29:20 2008
Date: Fri, 4 Apr 2008 16:40:36 +0100
From: "Coleman-Smith, PJ (Patrick)"
To: Thomas Davinson ,
"Lazarus, IH (Ian)" ,
"Thomas, SL (Stephen)"
Cc: "Strachan, J (Jonathan)"
Subject: AIDA - Board drawing for comment
Hi All,
Please could you look at the attached drawing of the pcb that will
connect the ASIC mezzanine boards to the detector.
The connectors and four pcbs are shown along with the start of the
wiring from one connector to the 0.625mm pitch kapton cable.
The cable is shown merely as a set of pads at the appropriate spacing.
I would like your comments about wether this an acceptable way of
proceeding ?
As you will see the four pcbs are placed to give a 10mm gap between the
two main boards which should work with fitting the larger decoupling
capacitors between them.
I look forward to your comments.
Tom and Ian,
Please could you comment on the HDMI document.
Thanks all.
Regards
Patrick
[ Part 2, "ERNI to Kapton pcb.pdf" Application/OCTET-STREAM (Name: ]
[ "ERNI to Kapton pcb.pdf") 32KB. ]
[ Unable to print this part. ]
|